Floresta e Ambiente
https://www.floram.org/article/doi/10.1590/2179-8087.105514
Floresta e Ambiente
Original Article Forest Products

Influência dos Parâmetros Dimensionais da Pilha na Qualidade da Madeira de Eucalyptus spp. Submetida à Secagem ao Ar

Influence of Wood Stack Dimensional Parameters in Quality of Eucalyptus spp. Submitted to Air Drying

Liebl, Osmar Andrei; Loiola, Pedro Lício; Zen, Linéia Roberta; Klitzke, Ricardo Jorge; Rocha, Márcio Pereira da

Downloads: 0
Views: 1065

Resumo

Este trabalho teve como objetivo avaliar a influência da largura da pilha de madeira e da espessura dos separadores na velocidade de secagem, nos defeitos gerados e da distribuição de umidade na madeira de Eucalyptus spp. Foram testadas duas larguras de pilhas (1.800 e 900 mm), ambas com 3.000 mm de comprimento, construídas com separadores de 20 e 25 mm de espessura. Foram avaliados a velocidade de secagem, a distribuição da umidade final e os principais defeitos gerados após 90 dias de secagem ao ar. A redução da largura da pilha ocasionou um aumento da velocidade de secagem, sendo o resultado mais satisfatório para a pilha confeccionada com separador de 25 mm de espessura. Para a qualidade da madeira de Eucalyptus spp. após a secagem ao ar, houve influência da redução da largura da pilha, a qual reduziu a umidade final das tábuas e a variação de umidade entre as tábuas, e os defeitos gerados foram inferiores aos limites estabelecidos pela norma.

Palavras-chave

pilha de madeira, taxa de secagem, umidade final, defeitos de secagem.

Abstract

This study aimed to evaluate the influence of the width of the sawn timber stack and thickness of the stickers in the drying velocity, the generated defects and moisture distribution within the stack in Eucalyptus spp.. Two widths of stacks were tested (1800 and 900 mm), both 3000 mm long, constructed with 20 and 25 mm thick stickers. We evaluated the drying rate, final moisture in distribution and main defects generated after 90 days of air drying. Reducing the width of the stack caused an increase in drying velocity, the most satisfactory results for the timber stack made with 25 mm thickness. The reduction of the wood stack width influenced the quality of Eucalyptus spp. after air drying, showing a decrease of the final moisture of the lumber boards. The moisture variation between the boards and the defects generated were below the limits set by default.

Keywords

timber stacks, drying rate, final moisture, defects drying.

References

Associação Brasileira de Normas Técnicas – ABNT. NBR-14806: madeira serrada de eucalipto. Rio de Janeiro; 2002.

Associação Brasileira de Normas Técnicas – ABNT. NBR-7190: projeto de estruturas de madeira - determinação das propriedades das madeiras para projetos de estruturas. Rio de Janeiro; 1997.

Batista DC, Klitzke RJ, Rocha MP, Muñiz GIB, Batista TR. Volume loss as a tool to assess kiln drying of Eucalyptus wood. Floresta e Ambiente 2013; 20(2): 250-256. http://dx.doi.org/10.4322/floram.2013.017.

Batista DC, Klitzke RJ, Rocha MP. Qualidade da secagem convencional conjunta da madeira de clones de três espécies de Eucalyptus sp. Ciência Florestal 2015; 25(3): 711-719. http://dx.doi.org/10.5902/1980509819621.

Batista DC, Klitzke RJ, Santos CVT. Densidade básica e retratibilidade da madeira de clones de três espécies de Eucalyptus. Ciência Florestal 2010; 20(4): 665-674. http://dx.doi.org/10.5902/198050982425.

Bauer K. Development and optimisation of a low-temperature drying schedule for Eucalyptus grandis (Hill) ex Maiden in a solar-assisted timber dryer [thesis]. Hohenheim: Fakultät Agrarwissenschaften der Universität Hohenheim; 2003.

Bekele T. Degradation of boards of Eucalyptus globulus Labill. and Eucalyptus camaldulensis Dehnh. during air drying. Holz als Roh- und Werkstoff 1995; 53(6): 407-412. http://dx.doi.org/10.1007/s001070050120.

Campbell GS, Hartley J. Drying and dried wood. In: Hillis WE, Brown AG, editores. Eucalyptus for wood production. Melbourne: Academic Press; 1988.

Chen PYS, Rosen HN. Drying yellow-poplar in a highly efficient solar kiln. In: Proceedings of 30th Annual Western Dry Kiln Clubs; 1979; Coeur d’Alene. Idaho; 1979. p. 23-32.

Galvão APM, Jankowsky IP. Secagem racional da madeira. 1. ed. Nobel: São Paulo; 1985.

Klitzke RJ. Secagem da madeira. In: Oliveira JTS, editor. Tecnologias aplicadas ao setor madeireiro. Visconde do Rio Branco: Suprema Gráfica e Editora Ltda; 2007.

Loiola PL, Juizo CGF, Marchesan R, Klitzke RJ, Rocha MP. Drying of wood from Mimosa scabrella, Eucalyptus dunnii and Tectona grandis in solar kiln, in south Brazil. Australian Journal of Basic and Applied Sciences 2015; 9(5): 445-453.

Loiola PL. Secagem convencional da madeira de teca (Tectona grandis L. f.) sob diferentes condições [dissertação]. Curitiba: Setor de Ciências Agrárias. Universidade Federal do Paraná; 2015.

Lumley TG, Choong ET. Solar drying of wood in Louisiana. Baton Rouge: Louisiana State University and Agricultural and Mechanical College; 1981. 55 p.

Marchesan R, Loiola PL, Tecchio MM, Juizo CGF, Rocha MP, Klitzke RJ. Avaliação das técnicas de anelamento e inserção de sabre em plantios de Eucalyptus grandis visando a qualidade da madeira serrada. Revista Científica Eletrônica de Engenharia Florestal 2015; 45(4): 695-704.

Northway RL. Drying strategies for plantation-grown eucalypts. In: Proceedings International iufro wood drying conference; 1996; Quebec. Quebec: IUFRO; 1996. p. 289-296.

Paes JB, Loiola PL, Oliveira JTS, Braz RL, Klitzke RJ. Efeito de soluções salinas na estabilidade dimensional das madeiras de Corymbia tolleriana e Eucalyptus cloeziana. Scientia Forestalis 2015; 43(106): 105-125.

Ponce RH, Watai LT. Secagem da madeira. Brasília: Instituto de Pesquisa Tecnológica; 1985.

Rocha MP, Tomaselli I. Efeito do modelo de desdobro na qualidade da madeira serrada de Eucalyptus grandis E Eucalyptus dunnii. Cerne 2002; 8(2): 70-83.

Siau JF. Wood: influence of moisture on physical properties. Blacksburg: Virginia Polytechnic Institute and State University. Department of Wood Science and Forest Products; 1995. 227 p.

Simpson WT. Dry kiln operator’s manual. Madison: U.S. Department of Agriculture; 1991. 274 p.

Souza JT, Trevisan R, Denardi L, Stangerlin DM, Vivian MA, Haselein CR et al. Qualidade da madeira serrada proveniente de árvores dominantes e médias de Eucalyptus grandis submetidas à secagem. Cerne 2012; 18(1): 167-174. http://dx.doi.org/10.1590/S0104-77602012000100020.

Stangerlin DM, Santini EJ, Susin F, Melo RR, Gatto DA, Haselein CR. Uso de estufa solar para secagem de madeira serrada. Ciência Florestal 2009; 19(4): 461-472. http://dx.doi.org/10.5902/19805098900.

Stöhr HP. The seasoning of South African grown Eucalyptus grandis and Eucalyptus saligna. South African Forestry Journal 1977; 102(1): 61-66.

5a70945c0e88253b425dfcc2 floram Articles
Links & Downloads

FLORAM

Share this page
Page Sections